Chevy Volt and Electric 3 series BMW (Ev-36/46)

Not a ton of progress. Working on installing the hydrolic brake booster in place of the factory brake boster. The factory booster is the one with the larger dia cylinder on it (rh side on the pic on the right). The booster I am using is from a 97 Cobra mustang.

Thank you for the interest. Yes, with luck the hard part is over. We'll see how it goes from here. I don't think I mentioned the exact batteries as I'm still a little up in the air about which ones. Right now the needle is leaning toward Deka 9A31. It's an AGM battery with 100Ah. Thinking I might as well go with 156V the max voltage for the controller and use 13 batteries. I still do not feel confident I know enough about batteries but comparing the cost and weight of some similar batteries they seem pretty good. I still worry it won't be enough Ah as seems trying to predict the exact range is difficut. Guess I'll have to make a decision soon though.

With the rover out of the garage the electric car could FINALLY be brought in. Thought I'd take a couple pics of it first "drive" into the garage. I also loaded the motor and trans into the car. Still deciding on engine and trans placement. I'll probably go with the factory placement for the transmission but I have been toying with moving it back 8". Makes for a lot of extra room in the front. The driveshaft from an automatic car is 8" shorter than the manual car and bolts up so that would be no issue. However customizing the shifter seems like a big pain. My time is probably better spent elsewhere on the car. Other task was to remove the tank. This was actually quite easy. Remove the boot from the e-brake lever. Remove the nuts on the cables. Pull them out from under the car. Take out the three bolts holding the tank in and volia. After I had it out I found it still contained gas. I was under the impression it had been drained. So I pumped out 4 gallons ...

Progress was delayed a bit as my rover needed some love. Here is the sparkly clean engine after re fitting the heads and rocker arms Of course a good helper is the key to a successful job (torquing the head bolts)

http://www.youtube.com/watch?v=zjhz9f9WXA8

Here's a screen grab from the cutting process. I have it in movie form but it pretty much looks like the picture with the noise of the saw going I put the bolt holes into the transmission adapter plate by bushing the trans bolt holes with some thin metal then drilling through the bolt holes. Then enlarging them to the right size. On my trans the locating dowels are in the same location as a bolt hole so I drilled that through the bolt hole. Counterbored with the closest standard drill size to the dowel hole. Then used a rotary file (round dill bit like attachment with a flat bottom. Kind of like and end mill) in my drill to enlarge them slightly and I mean slightly enlarge the hole and cut a square edge at the bottom of the hole. Worked great. As others have done I then put the motor spacer plate on and the trans adapter plate and assembled them so they were against each other but not bolted together. I then spun the motor to center the trans. Drilled and doweled the two plates tog...

Nothing really new to report. Just thought I'd add some pictures since pictures are fun. Notice how close to the trans I mounted the motor. The larger plate is .5" thick and the smaller one about the dia of the motor is 5/8" thick. No modifications to the transmission side were required. The extra space may not matter. Have to see but either way a thinner spacer is lighter. By the way I cut out the plates myself (exception being the precision hole in the motor spacer plate) using a simple hand jigsaw and an with an aluminum blade. What I thought made it go well was to pour water on the blade/plate to keep things cool. To do the motor spacer plate I'd say it took just under an hour and a gal or so of water.